Got the axles out. The key this time was having my wife hold the axle straight/parallel and turn it slowly while I did the “wrist flick” thing with a prybar and it came out with such little effort I actually asked aloud “did that just actually...
No, the 2G ECU wants to see the various factory control solenoids responding or it will throw a fault code. By keeping them plugged in you fool the ECU and you avoid collecting water in the connectors which can short out the drivers on the ECU board.
WTF
Op, that's the factory boost control solenoid.
As Paul says, there's no factory boost sensor and the instrument cluster gauge is just an ecu approximation of.. some kind of airflow. Lb/min based on the t25 airflow at rpm and mass airflow...
You never disconnect anything. Boost gauge doesn't have a sensor. It's just an ECU calculation. It's worthless for measuring boost. What are you trying to do?
Screw that, if I ever make it down to see your car I'm going to crawl under it and stare intensely at that cross member. Perhaps even critique it.That being said...
Nice.
Is it ego? (uh yeah) - Is it homage? (definitely). I'm trying to build a version of the 2G Eclipse that Mitsubishi could have built as a factory prototype - An amalgamation of the best stock parts and minimalist modifications pushing out the...
Check out MPXH6300AC6T1 (3 bar) and MPXH6400AC6T1 (4 bar). These work and are tiny. So, maybe anything more is designed larger to look important or stand out as a mod?edit agreed above, AEM stainless is what I would go to as well. I think 3...
Thank you - really. I find keeping a clean setup makes diagnosing issues easier. As soon as I see grease, oil, dirt whatever collecting - finding and ending the issue saves me from catastrophic failures and general unhappiness.
https://www.diyautotune.com/product/map-gm-3-bar-map-sensor/Maybe try that one? It talks about the cheap chinese made Delphi units coming apart on people, and that theirs apparently don't have that problem?What worries me is the Omnipower...
Slow down now - I upgraded to the AEM 3.5 bar for Speed Density back in December: LinkThere was a whole thing about signal noise at high rpm and such.This GM sensor came with the Autometer boost gauge, so I left it connected, just for the...
I’m wondering if this is what they are supposed to look like. The sensor is in the square box filled with epoxy, the rest of this sensor is empty space with 3 wires from the actual sensor to a plug.I dunno - I call shiningans - I think this is...
lmao either you missed it, or i asssume you dont read the posts 😂 i put it in there, home made my boy. cost me zippo, grabbed a manifold heatshield i had laying around off some random car, i kept it around because it had that nice bend you see...