2g Center Console removal

CONSOLE / SHIFTER BOOT REMOVAL​

this is done on a 2nd Gen, its alittle harder to do then a 1st Gen.

On a 1st gen you basicly remove your shifter knob and yank up on the boot
____________________________________________________________________________________________

Remove the ashtray/cup holder ( just kinda yank up on it )

There are 2 Screw under this assembly holding the concole to the floor.

You must be logged in to view this image or video.

2. Un-Screw the shifter knob, and pull up on the boot to dislodge the bushing.

There is a little light thats shines on the ashtray, twist out the socket.

You must be logged in to view this image or video.

Remove the HVAC/radio trim piece.Pull on it from the top, by the

outside/inside air. There are 2 clips near the top and just retainers at the bottom.

DONT pull on the bottom.

Remove the 2 screws behind the trim piece that are right above the radio.

You must be logged in to view this image or video.

Remove the 2 screws that Are on each side of the console in the rear seating area

You must be logged in to view this image or video.

Pull up on the concole a little and remove the wires connected to the lighter and unscrew the light on the lighter and ashtray

Remove the whole concole from the car.

Remove the 4 screws holding the shifter boot to the bottom of the console.

You must be logged in to view this image or video.

Unfold the flaps that are wraped around the shifter boot mounting ring.

You must be logged in to view this image or video.

Turn the entire boot in-side-out

Cut the zip-tie that holds the boot to the bushing.

Save the bushing and trim ring.

You must be logged in to view this image or video.

Turn your new shifter boot in-side-out.
Replace your bushing. (secure it with a new zip-tie)
Wrap the flaps around your Mounting ring.
Turn the boot right-side-out
Reverse the removal prosess
Enjoy! ​

Boot Examples Ive made for people HERE

www.turboeclipse.com ​