Reviving this thread from the dead. Does anyone have a diagram for the 2g relocation and no kill switch, there's alot of dead links for diagrams and so many different versions over the years. Was hoping to relocate my battery this weekend to the...

should i be running the factory pcv or should this just be a nipple since it goes right to the catch can?

70mm

2gHave it listed in the title block.Thank you

Used JMF Intake Manifold, has been tapped for an extra vacuum port on the back. Has some left over silicone on the backside around the ports. Was there to ensure there was no leaks on the previous installed barbs. Could use a good polish but no...

Wondering if I should also relocate my catch can, not sure if that will make a difference. Currently relocating the battery to the trunk so I will have that location open. Currently it sits down by the rad behind the passenger headlight

Everything else is dry. Was just on that inside, I was using break in oil with the new motor and still working out some gremlins with the tuning

Have a recently rebuilt S90 throttle body. Rebuild was done by Nick R.Comes with block off plate and new gasket. Has a small dent in outlet lip (can be seen in photos) but no issues with it. Small amount of gasket maker on it but can be cleaned...

Yes, that's how i currently have it

Should I remove the check valve in the meantime?

All pipes and couplers are dry. Was just in the manifold and coming off the head at the runners.I have the catch can down by the overflow tank. Currently route like so.FP intake, drilled into the side of it and that feeds the side of the...

This afternoon I removed my JMF smim and notice some oil sitting in the runners. Motor is still in break in after being built by MAPerformancd, have about 60km on it since then. I’m running a catch can off the valve cover with a check valve. I...

Hello,Was looking for some insight, I've been building the car over the past year and essentially ran out of time before the snow came to get all of the gremlins out of it. Originally we tried to tune it after the enging was built by MAP but...

Looking to purchase oem rear sway bar brackets that hold the bar to the subframe. Car is awd, not sure if that matters.Thanks

HelloJust installed the 02 housing from stm and I currently have an alternator and AC installed but the wastegate is pretty much on top of the alternator. If I loosen the alternator anymore the belt will be too loose. Just worried about it...

You use the top port with any sort of electronic boost controller. Otherwise you use the bottom port only.

Does the top port add additional pressure on the spring making it close faster or anything of that nature if both are used?

This is where the additional confusion is coming from. It shows the top port being used. Majority of the write ups on here don’t use the top

Hello,I just purchased a 38mm wastegate (Tial MV-S) and am trying to figure out how to install it. It will be paired with an STM 02 Recirculated housing , i have seen so many different methods of using the top port opposed to just the side...